Search results for query: *

So I'll be switching to a brake over the winter and trying to decide between the three valve body's. -Cope with their Billet valve body $890 + shipping to Canada - A&A $770 +shipping -ATI compuflow $948 Free shipping Also -How much deeper of a trans pan is required for a trans brake valve...

Hey guys so here's a new problem, When the car is cold and leaving the garage , it shifts into reverse or drive just fine. You can feel it bang. It rolls a little bit, then nothing. Acts like it's in neutral, untill you Rev it a bit then it bangs back in and it's good from there on out. The...

do any companies make a full manual valve body that’s forward pattern. All the ones I see are reverse. Not a trans go kit I need a new valve body

hey guys finally took the car for its first drive since the tranny got rebuilt and a new full manual transgo installed and the car won’t up shift from first. PRN all work fine. Put it in 1st and went to shift and nothing. I have the kickdown lever fully fastened back like instructed. Kind of at...

hey guys just finished up rebuilding my 727, with an all new Frank Lupo 4200 stall convertor and installed a tf3 full manual from transgo. Now I know you can either run a kickdown cable and adjust for the pressure or just tie the lever back. What would you do? This is a street/strip car Just...

Disregard thread

Disregard thread.

Hey guys recently installed a transgo 2. The install went very well and strait forward. Finally got the car ready for first drive of the year and noticed when I put the trans into first gear the throttle pedal is extremely stiff. Less stiff in 2nd. And normal in drive. Jacked it up and the...

I'm installing my TF2 shift kit on my 727 and everything is pretty straightforward. My valve body has a little hole that the instructions are asking me to plug But what can I plug it with??

I've pulled my axles on my 8 3/4 489 case because the rear end needs repair. How can I tell if my axle bearings need replacement. They seem a lil sloppy ( original tapered style)

Hey guys jumped in the duster today and notice every now and then when making a hard left turn from a stop I get a clunk from the rear drivers side. Feels like rear end noise. It only clunks/pops once during the turn Also I sometimes notice black tire marks on the ground following that tire.(...

Will 4.10 gears with 30" tall tire be too much for street use?? Or just right. Car will rarely see the track. Have a 2800 stall right now. Trying to decide between them or 3.91s

Does anyone know where I can get 4.10s for my 741 case. If its even possible....? Thanks