Search results for query: *

I'm confused. I have a 98 5.9 magnum that I was doing a leakdown test on before dropping into a 71 Dart. The biggest problem was that I had 100% leakage on number one cylinder. Took the head off and had carbon under the valve seat so I cleaned the cylinders, lapped the valves and put the heads...

My 5.2 is installed and I'm finishing up the loose ends. At this point I need to get a serpentine belt installed. I have removed the AC compressor and Power Steering pump (manual steering). I got a short serpentine belt that fits, making sure that the water pump and alternator turn in the right...

Hey Guys - I just bought a 98 Jeep Grand Cherokee Limited Special Edition! Wow, that's a mouthful! So far I have $125 in a 5.9 Magnum and Dana 44A limited slip rear with disc brakes. Not Bad. I also have a camshaft from a 92 Dakota 5.2 from a previous purchase. Of course, the 5.9 has the cast...

I have the trans bracket and kickdown cable off of a 98 5.9 liter Jeep and need to install them on a 904. Problem is: The bracket is too tall to mount to the transmission, it hits the tunnel of the body. The other end will attach to the bracket on the 5.2 EFI throttle body. I've seen other...

Well guys - I got the engine in, all wiring hooked up and was ready to test. Turned the key on and no smoke from the wiring. Good sign since I rewired EVERYTHING. So I turned the key to start. The engine went clunk. I already did a thread on this part. Pulled the engine and finally turned out to...

I had to pull my 2001 5.2. Now I will probably freshen it up with rings and bearings. Anybody know if a 5.9 cam will work in this engine?

Making progress - radiator in!

Background: I'm installing a 2001 5.2 Ram engine in a 68 Barracuda, keeping the original 904 trans. I'm using the Ram computer (PCM) and fuse panel/power distribution center (PDC). I'm keeping the original dash cluster with the analog gauges. The ignition switch has been completely rewired with...

I have a 2001 5.2 ram engine that I'm installing and connecting the data link connector (DLC) to go into the interior somewhere. Right now I'm just trying to get it wired in but the pin-outs do not match the diagram in the FSM. I also have a couple of other diagrams from other vehicles that also...

I'm putting a 2001 5.2 Magnum in my 68. My old 318 oil pan won't work. So I need a 360 car oil pan? Thanks