Search results for query: *

I have a few basic questions so I can get this 318 together and done. 1. With Felpro gaskets are the head gaskets that come with, all teflon coated? Or do you have to order them that way or is there a way to tell if they are? 2. I remember years ago when I built my last couple of...

On an A body can the engine (360) and tranny (904) be bolted together first than slipped right in? Normally I install them seperately which normally takes my brother and I about 30 minutes or so, but than we spend about 2 hours it seems putting all the bolts and starter in. I was taking some...

When I try putting my oil pump drive shaft in it is very tight. I know they are normally pretty snug but this seems way to tight. I am not sure if I can get it all the way down with out having to do some serious hammering on it. Any suggestions on what to do?

I was looking at an 87 Dakota with a blown 4 banger and 5 speed tranny, decent body for sale. The guy wants $300 but I think I can squeege him down lower. I have a 73 318 laying around in need of a good home. How hard would a swap like that be?

Can I use synthethic for break in?

I have just started my engine assembly and I allready hit a problem. My cam is stuck! It went in nice and easy till the last part when the front and rear get slid into there bearings. It jammed up so tight I could not pull it out. To make matters worse since I could not pull it out nor push...