My New Rotisserie
- Thread starter DusTed74
- Start date
-
4spdragtop
Well-Known Member
Nice job, cant wait to see something hung up on it
It's going to be a few weeks before I can get my car up onto it. I'll post some shots and let you know how sturdy it is.
In the meantime I'll put a caster in the center of the center span. Plus I'm working on a lifting system as well.
Ted
In the meantime I'll put a caster in the center of the center span. Plus I'm working on a lifting system as well.
Ted
Andy White
Well-Known Member
Hi
Why do you think you need a center caster? I have built this rotisserie and I am just curious.
Andy
Why do you think you need a center caster? I have built this rotisserie and I am just curious.
Andy
green1
Well-Known Member
Not dissing, but with no braces to the center, it will bind up. And still a mf with bigger tubing and the jacks on each end; still binds up.
Well my thoughts on the caster are these. That lower connector is a pretty long span to be unsuported and it flexes pretty good just pushing it around without a car on it. So just think if there is a stripped uni-body car on it without any type of frame connectors it would be constantly pushing and pulling on the entire car from the mounting points. Possibly creating an issue down the road.
I'm not trying to start a large debate here about whats right or wrong. All I'm saying (and a few folks here as well) is that a little added support will make this a little better design.
I'm not trying to start a large debate here about whats right or wrong. All I'm saying (and a few folks here as well) is that a little added support will make this a little better design.
As I posted earlier. I used the same plans, and added some mods. Holds my cuda fine. Pics are posted in new hemi swaps. Fine job you did.
PocketAces
Well-Known Member
I just scored this one off CraigsList for $600. One of the cylinders needs oil. Not sure if it's toast. The other one seems to work but the chrome is rusty on both of them. Worst case they're $55 at harbor freight. Also some of the casters have bad bearings and it's missing the square tubing that connects the two ends together.
I was thinking about modifying this one to include the threaded rod to adjust the center of gravity. Anyone think that's worth the trouble?
Also, I'd be curious to see what other's have done for mounting brackets for an early A body. This one has extra square tubing and brackets welded on. Not sure what they fit.
I was thinking about modifying this one to include the threaded rod to adjust the center of gravity. Anyone think that's worth the trouble?
Also, I'd be curious to see what other's have done for mounting brackets for an early A body. This one has extra square tubing and brackets welded on. Not sure what they fit.
-
Similar threads
