Dustert73
Stripping bolts since ‘10
Hey everyone, I have some parts from my project that I will not be needing.
360 la block that I believe was casted in 1975. The problem is two connecting rods broke and hit the block below the cylinder walls (included in the pictures), comes with main caps and main cap bolts. In the third picture down from the top there are cobwebs hanging in front of the left cylinder. The purple stuff is grease I put on the machined surfaces to help prevent rust. Asking $20
Dual snorkel air cleaner, cleaned up with hemi orange paint and a 360 4 barrel decal. Comes with a new filament. The center hole where the carb fits is out of round by about a 1/8 to 1/4 of an inch twords the back, you can see this in the bottom pictures. Should be able to straiten out. sale pending
1973 318 cylinder heads and 2 barrel intake manifold and carburetor. Make offer
May trade dual snorkel air cleaner for small block direct connection chrome valve covers and plain chrome air cleaner. Parts are located in Granville, Ohio 43023. Thanks FABO!
360 la block that I believe was casted in 1975. The problem is two connecting rods broke and hit the block below the cylinder walls (included in the pictures), comes with main caps and main cap bolts. In the third picture down from the top there are cobwebs hanging in front of the left cylinder. The purple stuff is grease I put on the machined surfaces to help prevent rust. Asking $20
Dual snorkel air cleaner, cleaned up with hemi orange paint and a 360 4 barrel decal. Comes with a new filament. The center hole where the carb fits is out of round by about a 1/8 to 1/4 of an inch twords the back, you can see this in the bottom pictures. Should be able to straiten out. sale pending
1973 318 cylinder heads and 2 barrel intake manifold and carburetor. Make offer
May trade dual snorkel air cleaner for small block direct connection chrome valve covers and plain chrome air cleaner. Parts are located in Granville, Ohio 43023. Thanks FABO!
