Articles from bryan Schaupp

  1. Torsion bar install

    I read a lot of conflicting information prior to changing to the 1.03 Bars.

    When all said in done it was pretty easy, Here are steps I used:

    1. Jack up car so front tires are off the ground and support with jack stands. remove wheel tire for easy access - picture #1
    2. Loosen nut for lower control arm Picture #2 This allows to move freely and prevent any extra binding
    3. release all pressure on height adjuster bolt/block and remove if desired picture #3
    3. Take clip out at rear of torsion...
Loading...
  1. This site uses cookies to help personalize content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.