How to install reproduction headlight adjusters into a front fender Compare Reproductions to OE (Other than color they look good, bought from Classic Ind.) Remove screw Slide metal part up off of plastic part (This allows for the plastic part to compress as it goes into the slot in the fender). Insert plastic and metal part into opening in fender. Use socket to press the metal part down, use your hand to keep back pressure so not to bend the support. On a side note the small screw holes next...
Tools / materials needed: · Faucet Puller Husky Compression Sleeve and Faucet Puller-63876 - The Home Depot · Roll pin Punch Set Roll Pin Punch Set (9-Piece)-61135 - The Home Depot · 3"x3"x3" block of wood, preferable hard wood like Oak, but Fur or Pine 2x4 will work 1. Cut a block of wood to approximately 3 inches square 2. Drill a 7/8 inch diameter hole (or the diameter of your brake handle) all the way through the center from one side, the grain should be perpendicular to the...