I read a lot of conflicting information prior to changing to the 1.03 Bars.
When all said in done it was pretty easy, Here are steps I used:
1. Jack up car so front tires are off the ground and support with jack stands. remove wheel tire for easy access - picture #1
2. Loosen nut for lower...
I got new seal and it was good 1/4" smaller than the gas tube and fairly thick rubber. Also awkward to hold tube and press on seal
I went to hardware to and bought a 1-1/2 inch PVC pipe coupler for .94 cents and made the job fairly easy.
Greased and slide the coupler into the seal. Then just...