altercation vs hemi denny

-
0ld school said:
thanks to everybody for the help. I just got on the list for one of Denny's kits. looking forward to it .the motor will a 588" aluminum block RB. about 900 hp. it is going into this....
Click to expand...
Old post I know but what dash cluster is this?
 
famous bob said:
Odd, there is no room/place to put a power steering pump on mine , unless way hi over the oil pump , motor plate would hinder that too.
Click to expand...
you're running a motor plate on a Magnum force K though if i recall right, without the motor plate, plenty of room for a PS pump. One can even get a smaller one from a late model vehicle that meets the PSI requirements of the rack if needed as well. I'll get some pics over the weekend, but my stocker fits.
 
dukeboy_318 said:
you're running a motor plate on a Magnum force K though if i recall right, without the motor plate, plenty of room for a PS pump. One can even get a smaller one from a late model vehicle that meets the PSI requirements of the rack if needed as well. I'll get some pics over the weekend, but my stocker fits.
Click to expand...

I don't want to have the engine weight on that k frame , not many people have anything good to say about them, so far the only thing I don't like about it is a little road walk from the rack/pinion slack. I did build a set of strut rods to strengthen the lower a arm set up ----------
 
famous bob said:
I don't want to have the engine weight on that k frame , not many people have anything good to say about them, so far the only thing I don't like about it is a little road walk from the rack/pinion slack. I did build a set of strut rods to strengthen the lower a arm set up ----------
Click to expand...
I don’t blame ya there.
 
You must log in or register to reply here.
-

Back
Top