Recent content by 1975 PROSTREET DUSTER

Check ballast resistor. Had same problem and ballast resistor was issue.

Asking for a friend who has a 67 barracuda. Problem is when he gets on it the front end rises up but stays up until you roll car or push down on front of car. Has tubular upper control arms but otherwise stock suspension. Upper arms were rubbing on mounts but are clearanced and free movement...

Update- Finally got around to getting 2nd opinion on x block. I sent block to Bill Richardson in Lynchburg VA. I had explained over phone to him about the dilemma with the block. He got block and inspected the main bore alignment and said no problem he can do it. The bores he sonic tested and...

Im sure 14" but you can contact him at 920-973-0196

Posting for friend. He is in Two Rivers WI.

SOLD

No info selling for a friend. Contact bill at 920-923-0196 text only please.

I understood your comments and was only curious about rumblefish's comment that he has seen/heard of more than a couple being only able to go to 4.04. That would mean a different pattern was used. And is contrary to info i have gotten which prompted me to post this thread. I am going to take...

Transmission cooler with filter. $25

Hubcaps $40

68 Barracuda tailight lenses. One is chipped. $100 obo.

67 Barracuda tailights complete. $250

Thank you guys for your inputs. I really appreciate it. So was there different patterns used for castings that made some thin bore and somethick bores?

Well thats what i always understood as being the case. I thought it would be very unlikely they would use a different pattern for casting x blocks. Not sure about sonic testing without boring, i have no knowledge in this area.

So they cast x blocks with different patterns?