Recent content by 35regal

crank sold-thanks!

rods STILL AVAILABLE IF ANYONE NEEDS THEM, EVERYTRHING ELSE SOLD

I noticed that the hughes solid camshafts and the ultradyne /bullet camshafts are very very similar in there specs. within like 1 or 2 degrees. im wondering if the same shop is grinding hughes and ultra dyne, mine is a 418 I have a solid 263/267 @0.50 637/651 with a 1.6 . rollers seem to idle...

LOOKING FOR A 34o single groove crank pulley. please pm me with details t:burnout:hanks.

i have had a set of these on my 340, then on my 418 . they been on here for 3 years, with a .637/651 solid ultra dyne. no problems. they are the 1.6 rockers, when i orig installed them on the x headed 340 i had to do some grinding so i had enough clearence between the spring retainers. i bought...

thanks fabo! sold!

yes i would be a great fit for a 400 plus stroker with 300 plus cfm capability.THATS WHY IM SELLING , MY HEADS DONT FLOW ENOUGH TO MAKE THE MOST OF THIS CAM.

solid roller- cast gear -no special oil pump drive.

Looks like cast iron -ill post a picture soon, thanks

I have a new sb roller cam. SOLID ROLLER, 270/275@ 0.50, with a 1.5 rocker 615/620 . Chet herbert# ce6g 200.00 shipped, new in box. Pm me with any questions.LOCATED IN ST.LOUIS MISSOURI 63011 ZIP HERE ARE A FEW PICS

i had a misfire at part throttle cruise,it ended up being the pick-up module in my msd dist.i cleaned the reluctor wheel while i had it out.

Replied pm. Thanks brian

650.00 shipped to the lower 48

all pms answered. duster373 had to withdraw do to unexpected circumstances. STILL FOR SALE, THIS WOULD MAKE FOR A SCREEEMING BOTTOM END.

i think i have the bugs worked out hoping to get a 10 sec. slip soon!