Recent content by 37 streetrod 413

Hi, what is the height from the top of the air cleaner to the top of the valve cover. Iam interested in hood clearence. Thanks Rich

from the rim of the balancer to the center of the belt is 2 inches. This is an aluminum pulley .

Would you reccomend a 6.25 or maybe a 6.3/8, to achive some overdrive And thankyou very much. Your experience, (wisdom) is appreciated.

I'am running a "65" 413 and it has a crank pulley of 5 1/8 stock and a aluminum water pump pulley about 6.25. Has a 180 highflow thermostat. Runs good in the country, but gets hot 210, plus in stop and go traffic. It has a 13lb radiator cap.

You could try this website. www.mortec.com

Sorry Memike, I'am new at this, but learning fast.

Box of parts I don't need anymore. Most came off a big block, with a 727 trans. asking 20.00 bucks. You pay the shipping, from area code 17560.

I bought this carb, and didn't use it. I bought the re-build kit, and completely took it apart, cleaned it, and re-assembled it. The carb is free, and works good. It would have been found on a 1965, 413, and other big blocks. The remaining parts in the kit go with it. I'am asking 125.00.

Yeah, that's what I thought. The adapter plate between the intake and carb, was for his vehicle only. So I just need the gasket. Thanks,

Mr. Dartish, I just got an AVS2 650, and I'am going to put it on my 413. Question, what did you do with the adapter plate? I'am putting mine on a performer RPM intake too. I got a used one, so I don't know if it came with the adapter or not.

I guess it's all there? it's just tight from sitting. Well, if that all checks out, i'll give you the thirty bucks. I can use the parts anyway. Thanks

How many miles on the speedometer? Do you know of or suspect any issues? Thanks Rich

This carb will work on my 1965 413. I bought a 3871 (600cfm) but it has no choke assembly, and yours does. I'am from Pa too. Lancaster, county. I'am thinking of buying this one and trying the parts on my AFB. Rich

Welcome from Pa. Another 70 plus hotrodder. Post pis's of your project. Enjoy the group here.

I was thinking of putting a set of 915's on my 65, 413. Do you have any idea what I would need to finish these heads. I have the stock 516 heads on now. I'am just east of you, 15 miles south of Lancaster,pa.