Recent content by 69KillerFish

  1. 69KillerFish

    Mod Interior Barracuda

    :thankyou:
  2. 69KillerFish

    Mod Interior Barracuda

    I've had my 69 Barracuda for 27 years. I've registered it in the MoPar Mod/Floral Top/Interior Registry. My car and story is #153 in the registry. From early on, I knew that it was part of the Mod Top family. I recently learned that it's 1 of 937, then I learned that my car could be one of only...
  3. 69KillerFish

    318 backfiring

    I took a trip out to its storage home for a bit. I changed all the plugs, wiring, coil wire and distributor cap. We looked at the ballast, nothing wrong there. I always carry a spare ballast and a few other oddities in my trunk just in case of emergency. I'm going out there in the next couple of...
  4. 69KillerFish

    318 backfiring

    This is why I like forums. Thank you everybody for your ideas. The carb is squirting gas. I pumped whatever was left in the gas tank out, all the gas in the tank is fresh. I'll check the ballast resistor, points and condenser next. If there is no change I will move on to the heads. I'll let you...
  5. 69KillerFish

    318 backfiring

    I changed all the plugs and wires after it started to backfiring. There was no change.
  6. 69KillerFish

    318 backfiring

    I cleaned and rebuilt the carb a number of years ago. I added sta-bil in the tank while stored. I put new gas filters on for the carb and in the tank. I also put fresh gas in the tank before I attempted to drive it to it's new home.
  7. 69KillerFish

    318 backfiring

    I had to park my Cuda for a couple of years. I would occasionally start it and let it run for a while. I had to move my car to another space. When I tried to start it, it was backfiring thru the carburetor and exhaust. It would barely stay running. I checked points, plugs and wires, all good...
  8. 69KillerFish

    [SOLD] Carter Thermo-Quad Carburetor 9109S 1978-79

    Mopar Carter Thermo-Quad Carburetor 9109S 800cfm - 1978-1979. Primarily used on the Dodge Lil' Red Express trucks. The numbers below the part number on the front are 1867. The name and numbers on the top are Carter Thermo-Quad 6-2363. It needs a good clean up and rebuild. $99 or best offer...
  9. 69KillerFish

    [SOLD] 1971 Dodge Dart Big Block Conversion Project

    Priced reduced to $8,900. I am also open to any reasonable offer.
  10. 69KillerFish

    [SOLD] 1971 Dodge Dart Big Block Conversion Project

    Yes, the torsion bars have been installed so the car will roll out of the garage. The car needs air cleaner assembly, battery, hubcaps, radiator fan and spark plugs. There may be a few other parts needed.
  11. 69KillerFish

    [SOLD] 1971 Dodge Dart Big Block Conversion Project

    As this car is part of an estate, we are nearing the time to close the estate. We are eager to sell this car. We are now offering the car at $9,900. Please feel free to ask any questions.
  12. 69KillerFish

    [SOLD] Dodge Redline Dog Dish Hubcaps - Set of 4

    Available from 68 to 71. The Redline hub caps are Aluminum originals. They have no dings or dents, just a few minor surface scuffs. All original paint. Asking $350.00 or best offer. These are located in Washington, DC.
  13. 69KillerFish

    [SOLD] 1971 Dodge Dart Big Block Conversion Project

    Our Father started a resto-mod on the Dart but passed away before he could finish it. It is roughly 75% completed. This car is part of an estate. What we currently know about the car - The car was a slant 6. There is a newly rebuilt 383 - 30 over with high flow heads. There is a 727-B trans...
  14. 69KillerFish

    [FOR SALE] 1971 Dart Swinger Big Block 383 Project Car

    Thank you very much for your interest. Can I answer any questions for you? Would you like to see other photos?
Back
Top