Hello j061093409.
I think you may recall I purchased a 72 hood from you a few months back. I was wondering if you would have a 74 rear bumper with brackets?
Thanks much.
Fred
I recently installed my newly rebuilt 340 and an airgap w/ Holley 4150 (650 DF-DP). the carburetor would not clear the hood. So I installed a 1 Inch spacer and reinstalled my K&N air filter. Now I am going with a modified hood and a 340 Hemi Dart scoop
I have a 72 hood which I can no longer use. The hood is in very good condition with no rust. The scoops have been made functional with approximately a 4x10 inch opening beneath each. The front molding and hood latch are not included. Asking $300. or o.b.o plus ship which would need to be...
Near new, less than 12 hours, MSD Billet Ready to Run E-Curve distributor. Fits small block.
part # 8504
This distributor is fully programmable, no external box required. I ran this for a little while last fall before pulling my motor for a rebuild. It is actually a little too tall for an A...
Thanks everyone for the great input on this discussion - gear drive vs timing chain set. There were some awesome and somewhat comical responses. I think I am going with a quality timing chain set. :)
Good Day everyone.
I am in progress of rebuilding/ replacing the top end on my 340. I plan to replace from the cam up. My question is - has anyone experienced installing a Milodon gear drive and if so how did it come out? Was it a worthwhile upgrade? I was toying with the idea of replacing...
Hey Darter6
It definitely sounds like a b1tch. I am positive it is the plug. I tried a 1/2 to 7/16 "insert" from a kit that i purchased but it didn't seem to make any improvement. i suspect cause the leak is within the threads from the inside out. The dents are kind of an indicator.
I...
Hello fellow A Body owners. I was wondering if anyone out there has experience with the oil pan removal on a V8 dart? I have a 72 Swinger with a center sump pan. My pan is currently leaking at the drain plug and I would like to remove the pan and repair the plug hole. It seems to be not...