a70duster's latest activity
-
ASame. When I was a kid, 8-10yo, my mom always had trouble backing up our boat so my dad taught me how to do it. By 12 it was my job when...
-
AI could watch the Florida boat ramp videos on youtube for hours.
-
ASure. It's a 72 D100 318/396 stroker, it has a 8 1/4" rear with 3.21 gear, on a set of 20x8 wheel 275/50-20, the tire measure 30.5"...
-
ADepends on the track and the day of the week. I have a buddy who had a 600 hp big block in his street Duster. It would run 10.90 at the...
-
AThat's not too much compression. Fix your cooling system and learn to tune a carb and distributor. I can run 12:1 on pump gas and iron...
-
A10.3 is NOT TOO MUCH FOR 93 OCTANE. tune it & drive it. If you can't tune it run a octane additive... either way just get it going and...
-
ANot quite correct^^^^^. Comp ratio is: the swept volume of the cyl with the combustion chamber volume added to it divided by the...
-
Aa70duster replied to the thread Those Running 3.73 And a TF w/ LockUp.. What's your highway Driving Like?.This was years ago but 3.91 and ~26" tires (auto) at sustained 60 mph was not fun!
-
AI do too, in fact I had thought about that. Then I thought what happens if it gets knocked over, oops, now they aren't in order...
-
AA 2x4 with 2 rows of 1" holes drilled partially thru it.
-
AI used a teensy controller and arduino. and some mosfets. I used oshpark to print the board. I'm no hardware engineer but it works...
-
AHey guys, I'm that chevelle guy lol. this is my fav video of it I ran it at the texas mile a few times, it put down about 850hp to...
-
AId use a stone hone. That way you can see the undercut below the ridge. You can rent these at auto parts stores. Ball hone is more for...
-
Aa70duster reacted to MOPAROFFICIAL's post in the thread Well I ordered myself some new valve seat cutters with .Wish I see the ad.
-
AHarbor Freight sells an engine support bar. I bought one and used it when I swapped out the factory K frame for my QA1 one. 1000 lb...
