Hi Guys,
Looking for a little info on how the quarters were undercoated inside trunk? Was it just vertical surface from front to back? How far forward?
Any help appreciated.
Thanks
hey guys,
For the record, its not a horrible noise. Its just obvious when I let the clutch out. I am running 80w 90 valvoline. was going to go for the valvoline 75-140 GL4?
Or go with what you guys suggested to start.
sorry for being that guys who responds many months later. I appreciate the help everyone. I suspect its the oil. Have not had a chance to change it out to something heavier. I did adjust the throw out bearing and that was not it.
After winter I am going to try a heavier oil (since its rally...
Guys,
thats a big help, thank you. Also I did the pilot and throw out bearing too, so basically I shouldn't hear a difference in clutch in clutch out in terms of noise? and I didnt think to check my throw out adjustment but I can always hear the noise intermittent so that's the first thing I...
Guys,
looking for little help. Have A833 4 speed in my 69 dart. I replaced the input bearing when installing trans because it was obviously noisy. The trans is still a little noise when I let the clutch out at idle. Is this normal for the A833?
also, anyone know will a '75 OD 4 speed trans...
Max, really I just need spindle bolts to lower ball joint but if its easier to send spindles with drums, I will seperate them out.
sent you a PM.
thanks!
Hey, how did you do with the oem style bolts? any luck. I notice they do make contact when you lock the wheel out, I will probably end up with a generic grade 8, but would prefer the dome head.
Guys, looking for a little help.
restored my 69 dart some time ago and noticed the head of the lower rear spindle to ball joint not is not totally against the lower ball joint, can anyone check theirs and tele if this is normal?
also, has anyone changed these? and what did you guys use if so...