Hello friends.
After a long time without publishing anything here, I have news for my Dart.
Finally I bought subframes to improve body rigidity. They were made here in Brazil by my friend Adriano Tilly.
Any tips on how to weld them in the car without problems?
Happy ney year to you all!
Hey Serj! This one that I bought was fabricated in november 1995. I have respect with tools. Always use the way the manual indicates. That´s why is good to have a lot of tool, each one for a propose.
Thanks 48jeep! I will not use the Snap-On TorqOmeter professionally, just a few times. I always backed my Pisttsburgh torque wrench when not in use. This is a good advice.
Oh Rusty, just bought it. I look over again on eBay and found not better. Have someone cheaper, but don´t look so nice as this one. But thanks a lot for the advice.
Thanks Daves!
I always search for properly use a tool or any other device. I used my Pittsburgh torque wrench very carefully and in the right way. The same will be with the SnapOn!
Thanks for the Tips.
Thanks guys!!
Now I have a click torque wrenche made by http://www.harborfreight.com/, Item #239.
They look good but I don´t feel that can do an accurate job. I know that dial wrenches are hardder to use. But I want precision first!
Thanks agains.
Thanks guys. Asking about the quality.
I have one made by Harbor Freight and want to replace it for a better one. I´m searching about possibilities.
How to know if they are accurate?