I made a sheet metal bracket that wrapped around the dash pad. It went under the top pad in the front about 2 inches. then folded back around the pad. formed it to go to a hole the previous owner had drilled in the face of the dash just to the right of the cluster.
Hi guys! Sorry I haven't been on here much lately. To much stuff going on. Right now I'm putting a new bullet in the chamber of the Duster. A Blueprint engines 408 stroker. 450Hp/500 Tq. I hope to be on here more now!
Get the Hobby Lobby app for your phone. Always a 40% off coupon for stuff. Granted you can only use it on one item. But who says you can't go through a few times!!!
I've had Pro/Form rockers on my 340 for about 10 years. I had one loosen up on me when I first put them on. But I figure it was installer error! ME!!! Haven't had any problems with them. Might be going on the new Blueprint Engines motor that I have coming to replace the old 340. Its a 408 stroker!
I just notched the lower bump stop bracket also! Didn't do the upper arms yet. Wanted to do some driving this summer! I got to say. I am very pleased on how nice they fit. I'll put the upper arms on this fall. Then get it aligned.
I got a pair of tubular upper Arms and QA1 coil overs with adaptors. The upper arms look close. But the coil overs look like they hit the upper bump stop. Has any one done this with just cutting off the factory upper bump stop? I'm hoping I didn't get taken to the cleaners with this!