So I'm deep into my a-body manual conversion and come to find out that the drivers side header lines up directly with the Z-Bar. Great. Any ideas on how to remedy this this problem?
This car is a 73 dart swinger with a small block 318 for extra info.
Thanks.
Alright I am back at it again with the a833 questions... So I'm reassembling the transmission with the new 66-67 tail housing I bought to adapt to the slip yoke and this specific year of tailshaft requires a 207 bearing for the rear (6207 N/C3) and I can't seem to find a snap ring with the wierd...
Alright so I got a 64-65 a833 with the wierd small speedometer gear, not the larger a904 gear. Its also been snapped off. Anyways is there any way to convert it to electronic like the a904? Or do I have to get a later model tailshaft to be able to fit the bigger one?
Alright so to be clear, I want to take the brake and the clutch pedal and the linkages coming off of them from a 3 on the tree car to put into my car. I already have a factory hurst shifter from a four speed and I plan on putting a floor hump in. I am not concerned about the shift linkage only...
So I've recently gotten myself into a manual transmission swap, I am swapping a 4 speed 64-65 a833 into my originally automatic 73 dart swinger. Since 4 speed pedals and linkages are hard to come by I was wondering if I could take the pedals and the linkages out of a old 3 speed Chrysler. I...
Looking for a A833 transmission along with all of the linkages and pedals and stuff in the salt lake UT area. I'm trying to manual swap my 73 dart, the existing transmission is a A999, if you have any leads let me know, thanks.
The car is snowed in right now so I don't 100% know right now but It is in that ballpark. Iwill try adjusting the timing when I next get the car out. Thanks