are you taking orders to get a run going or do you have the adapters made and ready to turn and burn ? how would I get payment to you have not bought anything from FABO before
I think you have alot of things going on and sadly you can not trust new parts to function correctly now adays.
popping in the exhaust is from a rich or unburnt fuel in the pipe. Check your gap on the plugs are the wires seated in cap correctly, is the rotor in contact with the cap, does the...
hey just wondering what is over priced the rims are available especially for the later large bolt pattern but the centers are not that easy to come by. Is indio close to pomona is So. Ca. They have that swap meet 4 or 5 times a year. It is huge and good prices from most the people. reason I...
Het Artie if your looking for brand new heads I can't help you but I do have very low mile Edelbrock rpm heads, but have a cloyes timing set new if your still looking. and lifters and cam but cam is stock 340 hydraulic flat tappet
cool project seems you have the pieces needed to get a good start. if for some reason you end up pulling the 6 cylinder let me know I'm looking for a 225 with its 904 with same build and sequence numbers. yours are date correct for my project to rebuild. I do wish you luck with your sale, if it...
do you have the radio and dash piece for the radio and heater controls. What about the Jack assembly. How about the switches. Is the wiring harness any good especially at the firewall connections?
how much for tail lights, wiper motor , switch, and what condition is the main harness with the fuse block and bulk head connector. Do you have the jack assembly? the emissions parts ? shipping to 94903.
I have never heard of the trick using molasses. I have the rims that could use a good wash and rinse and repeat if need be, So I will try it, thanks for the tip.
Good tips for the rims because sand blasting blows and I was also going to point out the white vinegar works well and you don't have to run full strength it is acidic and it will eat metal but I use it all the time to bring back old metal files. If using on nuts and bolts I have to chase with a...
With my conversion from a LA 318 to the RB 440 I installed a fast ratio manual steering box along with a longer pitman arm and idler arm, so better then 20:1 ratio, but is effected with the smaller tuff wheel I am using. I also relocated the battery to trunk which freed up room in the engine...
I have a proparts k member that is in my dart and bought that in the late 80's and according to what Proparts claimed their K member they sold was supposed to be a an exact replica copy of the dc k member. Does yours have the spool motor mounts and a provision for a later style sway bar that...