Recent content by Dave1967

I have a b body housing with the spring pads re welded to a body width. I think I'm 3 hour drive from were you are. If you want to pick it up I would say 200.00

I have been keeping up with your progress. On the home stretch I see.

We have been more than patient.

Very cool guys.

I left the bumper and used foam on the door. If I remember right if the bumper was removed the door would get stuck in the closed position.

Fender well

As I remember I put foam on all the doors to help them seal. But with out foam everything will still function. Most all the heater boxes leak so what I did was put a manual shut off valve on the heater hose. Oem vacuum valves expensive. Home Depot manual valve cheap. Good luck.

Rusty is right

Okay. Similar set up. 340 six pack in barracuda. Same problem in traffic. Same timing. Cam 528/528 solid lifter cam. My over heating solution. Griffin 2 core. Two cores are 1.25" wide. Hayden short fan clutch with viscious fan. 5 blade. Aluminum fan shroud. Two 10" electric fans mounted on the...

The radio is pretty cool. But wouldn't Jason want blue tooth satellite capabilities? Lol. Remember my diesel son, well we just got a 2002 diesel 3/4 ton extended cab full bed ram truck. Another project, however my son, nick works just as hard as Jason. Nick will be a senior in September. So are...

Yes with a new yoke.

Flip the front spring hangers. Little longer rear shackle. Drop the front spring hangers and drill new holes.

No heat. But it does have the blower motor. Does have 150 speedo.

Move the steering column all the way over. There's quite a bit of room for movement. Then put 1/8" washers on the side of the steering box. This kicks the box at a little angle, enough for steering coupler to sneak by number 7 tube.

No