Recent content by Deeeno

I am in need of the drip rail mouldings for a 1965 barracuda . Anyone have some in good shape for sale ?

I have a 65 barracuda formula S 4 speed car with a 273. What was the original rear diff ring and pinion gear ratio ??

Thanks again for all the help turned out to be a bad “new” VR I appreciate all the help !

Thanks all the help guys ! Turns out the new VR was bad I got another one and it good !! I really appreciate all the advice !

Ok so I ran the ground to the second “field “ terminal stil don’t see anything more than I had at the battery so I pulled off the green wire from the VR and ran a jumper from that to the battery and it does what you say it should , it was about 12.8 and kept rising , then I ran a separate ground...

Thanks I will give it a try

Yes it electronics inside not the “old style in the VR

Here are some pics of the alternator I got on rock auto it was the best one that was a direct fit not sure of the brand on the VR

Thanks for helping I will get some pics tomorrow I really appreciate it

When I test the battery I get 12.6v when I start it and check again it’s the same exact reading it makes no difference whether I run the rpm up nothing changes so to me it seems it’s not getting anything as far as any charge. Alternator is an ac delco remanufactered and it is the second one I...

I am pretty sure I have a charging problem because it just seems to run off the battery till it dies. Everything is new in the engine compartment even the wiring harnesses , when I start it and check it with a meter it reads the exact same as when I test just the battery without it running ...

this kind of sounds like maybe my problem , when I check the output there is nothing when I check the out put at the alternator it kinda bounces with my test meter , where did you get a smaller pulley?

Thanks !

Thanks !!