Recent content by enginedoc12

Pics of the 65

I dont have the time to get everything done! Looking to sell a pair of Barracudas. One is a 64 273 V8 car. Near as I can tell from the dates uncovered from starting the restoration it is a July or August car therefore it is a pushbutton. Complete car with extra side glass, interior and exterior...

35steveq where did you source the clips? I need them for a 64 Barracuda.

Do you have that valance off this vehicle?

Does anyone know the member that modifies early a trans cross members for dual exhaust and if there are any available?

It may have been screwed on but the seal area is very small because of the angle differential. I wouldn't trust it.

There may be 1000 lbs on the trailer but rolling weight is different. There is probably less than 400 lbs rolling weight. That's why you can move it by hand if it balances or push your car if needed.

That's not an AN-10 folitting. It is a 45° flare fitting. They do not interchange. The difference is noted in where the threads start. If there is a space from the flare to the beginning thread (like in the pic) then it a 45°

The slotted holes you see between the 2 1" holes are where the front of the hitch mounts. Looks like the other four are not on your rails but would be the plate behind where the spring hangers mount. If your welds on the rails and pan are good, that would be plenty strong.

there I s plate behind the spring hanger and one bolt on the frame rail

Uses 6 1/2 inch bolts.

Thanks for your help.

Looking for the plastic rocker molding clips for 64-65 Barracuda. Thanks