I installed Sniper EFI in my Dart but decided to go back to carb setup. These parts were used for approximately 15 months and a couple thousand miles. All are in very good condition, distributor cap and rotor were replaced less than a month before removal of system.
Prefer to sell as a set...
I had one in my Sniper conversion in a 66 Dart. Easy to install and worked fine. I did not think it was loud, once primed at start it could not be heard over the dual exhaust. I ended up pulling the Sniper due to some electrical gremlins that I was tired of chasing.
I have a used pump...
I have a 3 groove crank pulley for sale and would be happy to send you any measurements you might need. It was on my 1978 360 manual steering , but I replaced all pulleys with CVF Racing aluminum (with their own spacing).
I put a seven blade '340' fan on it and a high CFM pusher fan (mostly used when running A/C or in heavy stop and go). Unfortunately not enough room for a good shroud or clutch for fan, I am sure that is best but my fitment is too tight.
Various left over parts from my cooling activities/testing with my 360 LA.
All located in New Port Richey FL 34655.
All prices are shipping included in continental U.S. Paypal.
CVF Racing Crankshaft Pulley 2 V High Flow, SCRL2CR-HF New In Box $85 shipped
SPAL VA18-AP10/C-41S 16 inch...
This is a current Ebay ad for what I believe are the same ones I purchased September 2020. Mopar 340 HP Exhaust Manifolds Gaskets CUDA AAR CHALLENGER T/A DART DUSTER | eBay
I have the aftermarket copies of the 68-71 340 manifolds in my 66 Dart with a 360. As RustyRatRod said they are good but your fitment may vary. I am running TTI 2.5 inch manifold back exhaust (a challenge but I made this work). 90 degree oil filter and smaller filter is a must.
The...
Using the V-Belt pulleys for Alt, Crank, and Water Pump. Quality is very good and I found alignment best when using all of their pulleys (not a mix with 'stock').
If you are referring to this one: Holley 255 LPH OE Style EFI Fuel Tank Modules part # 12-319 then I just installed one with my Sniper EFI build. It installed very easily in the stock tank. Wiring is four wires. Pump has regulator so I am getting right around 60 psi to the Sniper throttle...
Not sure if Dart GT and Valiant Dash is the same, but here is a picture of a 'spare' I have from a 66 Dart GT. Pen included for sizing. Hard to see in the black upper section, but on the left is Fan slide opening and right side is Heat controls (2 slots).
Thanks very much for this post and info. I am doing an install of Sniper EFI to my 360 1966 Dart. I am using the Sniper Hyperspark Coil/Ignition/Distributor along with a Holley in tank pump. Not expecting a big improvement in performance, but do expect drivability improvement.
My 65 GT has two allen head bolts in those locations. They don't appear to be the originals as this was a 'restored' car, but they are both allen head.
Sorry for the delayed response, I was out of town. I don't have either of those pieces. At some point I will do a detailed inventory and post up a for sale item.