No sir not yet. Pulled the engine apart a while back to change the heads and cam only to find a lot of metal shavings and the cam bearings destroyed in an engine with only about 500 miles on it. So another engine is at the machine shop getting prepped. This time a reputable machine shop who...
Ok Guys.... Sorry if it's been asked before but I couldn't find anything. I wanted to know what is the best intake to run on a W2 engine. The RPM will be from 2800 to 6800. Basically now a street car but driven hard. Don't know anything about them but I was told the Holley street Dominator was...
To put your mind at ease call Cometic and talk to them yourself. That way you aren't going by second hand information. That's what I did. It will help you make up your mind about which way to go.
No!!! Just clean them up so the outer layers are nice and clean. Inner layers should be fine. That's all I did. Can of Gumout and sprayed with copper gasket sealer. Done!!!!!
Cometic told me I could reuse them after cleaning them and with a light coat of copper spray coating but they also had to be used with the same heads and block they were originally used. Could not be reused if I was changing the heads. I tried it and they have been fine on my engine and I have...