I have a 65 A100 pickup with a 225 engine three speed tranny. I'm not sure how many quarts of oil it takes. Also, would there be any problems using a 5-30W synthetic in the engine? Thanks
I have a 65 A100 with a slant six 225. I'm confused as to the correct orientation of the dip stick handle. When I put it in one way, the oil reads beyond full. When I flip the handle and install it the other way, it reads oil is low. Is the dip stick in the correct orientation if the markings on...
i have an A100 slant six pickup. Two times now after driving, fuel is spitting out from the filler neck. This doesn't happen when filling the tank only while or after driving the truck. Once while I was at a stoplight and a guy told me my truck was spitting out gas, another after a short 5 mile...
Thanks, guys for all the suggestions. I finally got the roll pin out after heating up the shaft and using some masonry drill bits. I had to go through 4 bits but along with the heat I was finally able to drill out approximately half then punch out the remaining roll pin. Can't believe how hard...
I changed out the T-handle on my emergency brake shaft on my 65 A100. The new plastic T-handle also uses a rolling pin, however, I have not had success drilling out the old rolling pin. I even tried to drill a new hole through the emergency shaft and nothing seems to phase the steel shaft. I...
I did look into a replacement as you suggested, Barbee, but man are the little ones pricey. If you know where I can find one at a reasonable cost I'm all ears.