Hey i saw that pic of the small block radiator aluminum and you put a pic of the ford contour dual electric fans fitting on there. I want to go the same route and I just purchased the fan. How did you get the correct wiring/plug connection that is shown in the pick? Did you build it or buy the...
I believe hughes stated on the website when these heads were offered is that thry were 179 cc runner and 62 c.c. combustion chamber. Just trying to get actual numbers because I'm just guessing at this point. Trying too see whats the biggest cam I can go to while keeping these heads and actually...
I have a set of hughes iron ram heads on my 408.
I have been trying to find out the specs of my heads as far as the combustion chamber and runners cc.
Hughes 4676SP was the part number
Says They are cnc super st prepped
The invoice says they did a racing valve job
Cnc chambers
2.02 and 1.620...
Hello I have a small bolt pattern dart with a 8.75 rearend. I switched it to large bolt pattern Moser axles. I bought 10x 2 1/2 backing plates and shoes. They bolted up fine. I purchased Durago #8878 10 inch drums. I put them on and I have alot of rubbing going on. Wear marker of rubbing on the...
Hey guys in the process of putting a new harness in...i was dumb and forgot to take pics for visual reference. I got it pretty much taken care of but I can't find where some of these connections g0
Hello. I have a 1970 dart 340. I removed the dash to get it restored and found that the wiring harness is labeled 71 from previous owner. Gauges never worked. I bought a 70 dash harness to correct this, The harnesses seem to be almost exact except for a couple spots. I noticed on the 70 harness...
I had them Redo all my gauges and test them. Fix heater control. Restore the gauge faces with new lettering/numbers. Make sure Speedo working and fix some broken prongs on circuit bored. Along with restoring the front of gauge housing.
1,000 bucks. I did not send in Whole dash. And I bought...
Oh **** really? I'm way off. So voltage limiter is in the fuel gauge? I had instrument specialty redo it all. If thats the case I would assume they put one in and it works.
Hello I'm trying to find a new voltage limitor/regulator. I have a 70 swinger 340 speed car. I just got my dash and gauges redone and dont want to fry my gauges. I can't find a limitor regulator that looks like the one in my car. Mine has 3 prongs close together than 1 more a little lower. For...