Recent content by Jeremy

Pair Cragar Front Super Trick wheels For Sale. I bought these wheels new, never used on the street and always kept inside. $400.00 plus shipping (77510). Please text 409-795-0644

Thanks everyone for all your help, I finallyhave the correct seal, I got it from Ritter himself. I had the correct part number to start with but when I called the seal company they said they couldn't have made a mistake. Well the correct seal had the same number I have now., the correct number...

I am looking for a rear main oil seal or a part number for a seal for a Ritter block with a WET sump oil pan. i found on at Hughes Engines but it is incorrect. Thanks Jerry Davis

1 PAIR OF 3 1/2" X 15" SUPER TRICK WHEELS IN VERY GOOD CONDITION BUT NOT PERFECT. I BOUGHT THESE NEW YEARS AGO. THEY ARE 3 1/2" WIDE AND 4 1/2 AND 4 3/4 BOLT PATERN. $550.00 PLUS SHIPPING FROM TEXAS. TEXT JERRY @ 409 -795-0644

Yes they do. They are the 2.02/1.6 heads. As are all X heads. Thanks for looking.

I have one pair of 4448308 Small block Mopar head castings, never been an engine came new from the factory I blocked the head riser pasage with plastic steel, and they have a small amount of surface rust. they have the factory valve job and unused. The 308 is the best casting for a super stock...

ONE PAIR OF 340 ROCKER SHAFTS. $125.00 FROM TEXAS PLEASE TEXT 409-795-0644.

Yes, plus shipping, I'm not sure what that would be.

I think it may burn out after a very long time, but I have been blocking the heat for many, many years and have never had one burn out completely, only burn back less than a 1/4" after a long time.., I don't drive on the street though.. Thank you for your interest, I have several sets I going...

Ports aren't filled, just the passage to heat the intake manifold. They have plastic steel in them, could drill a small hole then knock the rest out with a small chicle. If you want to loose HP and heat the intake.

No they haven't but they are clean and if they were cracked it would be visible. The small block heads did not have a cracking problem until the later 70's whey they started making things lighter for emissions . I haven't seen early heads with cracks. Thanks for looking.

ONE PAIR OF '68-'71 340 HEADS BARE HEADS CLEAN BUT WILL NEED A VALVE JOB. I HAVE HAD THESE STORED SINCE THE EARLY 1970'S. THEY WILL NEED A VALVE JOB. THIS HEAD ONLY CAME ON '68 THRU '71 340'S AND THEY CAME WITH THE 2.02 INTAKE VALVE. THE HEAT PORTS HAVE BEEN BLOCKED. HEAD $500.00 FROM...

273 STYLE ROCKER ARMS AND SHAFTS, USED VERY LITTLE. THEY HAVE BEEN GROUND FOR VALVE SPRING CLEARANCE. $250.00 AND WILL BE SHIPPED FROM TEXAS. PLEASE TEXT 409-795-0644

i HAVE A 1973 340 THERMOQUAD FOR SALE, i HAVE HAD IT STORED FOR MANY YEARS. IT IS IN GOOD CONDITION BUT WILL NEED CLEANED UP AND A KIT. $150.00. SHIPPED FROM TEXAS. PLEASE TEXT 409 795 0644