I put a hose clamp on the new rubber hose over the metal ferrule where the original hose terminates. I also put some auto trans sealant in there just to make sure no leaks.
Yeah it's a tight fit getting the cable snaking up to the shifter. I had to make sure not to get too close to the...
Awesome thanks @WV64Signet but mine is a floor shifter. I believe the pushbutton is slightly different in procedure. I need to hold firmly selector lever in low 1 position.
I'll try it out tomorrow after work.
I greatly appreciate your help!
Yes @WV64Signet I just got the tech service manual. It's a great resource.
I accessed the lock spring through the cable well. It was easier than I had feared.
Now I need to adjust it properly because it doesn't shift well. Jerks real hard going into drive.
I need to remove the shift cable to re-sheath it and re-route it because previous owner had it where it was binding the throttle linkage. And it cut into the rubber causing a leak.
I was wondering if this end is threaded into the case or do I just pull it out? Thanks!
The cable got cut and trans fluid leaked out. Then I tried to remove cable from housing to replace cable. I carefully tried to remove the pin from the housing to release the cable and the housing cracked. I feel terrible I ruined this piece.