Recent content by Jofis

I am looking for a clean as possible trunk lid for my 73 Duster project. I am in Isanti and will travel to pickup within reason. Lemme know.

Thank you, But I am looking for the bracket that bolts to the trans the holds the bottom of the shift linkage. Has 2 bolts that hold it to thr trans and a hole for the linkage. Do you have one of those ?

Looking for the lower bracket that holds the lower shift arm pivot on a 904 trans. Not sure if the 904 and 727 are the same. This is in a 67 barracuda if that matters.

I will check there instead thanks.

Thank you very much. I think I will finally buy one from classis industries.

Have a 1967 Barracuda with a 318 and no A/C. WILL the 68-69 shroud fit this, realizing its not the exact same. I dont mind modifying slightly but otherwise will it bolt on and center on the fan??

NICE thanks much, thats what I needed.

Anyone have a set of the 1.6 ratio mopar performance aluminum rockers. Even 8 of them?? Dont need shafts, willing to try anything.

Does anyone have a cam card or recall the intake centerline specs on this mopar cam? Not the lobe separation......that I know is 112 degrees. Also anyone have a set of the mopar aluminum rockers laying around in the 1.6 ratio??

Are the front and rear bumpers on a 1967 barracuda exactly the same??

Sorry, Just made some room if you have some time to send some pictures. MUCH appreciated/

Looking for both left and right grill trim for a 67 barracuda. I am not sure if the trim is actually attached to grill parts as well.

NICE, LOL

65Val Thanks for the link I will check that one out as well.

How much do you want for it?? Ship to Isanti MN