Recent content by john franklin

Model number 8210,Big Block Chrysler 383-440 Indy 440-1, 440-C

for sale Brand new never taken out of protective cardboard T&D 440 150/150 Shaft Rocker Arm Kit - 1.5/1.5 Ratio, For Mopar BIg Block 8210 not going to need these,paid over 1375 for these,will take 1000 for a quick sale,hate to lose so much on these but need the cash for other Parts,im in wi and...

T&D 440 150/150 Shaft Rocker Arm Kit - 1.5/1.5 Ratio, For Mopar BIg Block part number 8210,these are brand new,purchased for a build that isnt going to happen,sold the heads,these are still in the cardboard factory roll up,never taken out,we paid over 1300 for these not long ago,will sacrafice...

Tried to pm you,

interested in a plate,how much

How much to make me one!!!:thumbsup:

I can understand that for sure

Actually the batwings in the pic are not even lined up,they are resting down on the valley plate,when I raise the batwings and line them up with the intake holes there is still a wide space,something's not right,this plate is not made correctly,not wide enough on a rb with the 240 heads,beware...

sending the trick flow back,may just use the old tub intake gasket,less screwing around with all this,so many fitment issues with all this stuff,trying to use newer made parts but not liking all these problems,I've sent back more parts in the last few months because of figment issues

Not sure what your saying,You dont pull a head to get the valley pan off

so yous is a little bit wider but not much here is a pic mocking it up with the bat wings

any way took the head gaskets off and put the heads on without them,heads laid nice and flat against the block and still this gap of about 1/8 of and inch,maybe slightly more,Im stumped if this plate measures the same as yours then why do I have this gap?something different about my heads?I also...

im going to take the head gasket off the block and set the heads on and check,also make sure the heads are on the dowels all the way,this is the only other thing it can be unless anyone else has and idea???LOL

also 19 inches long on each side

Not sure I was hoping you would know,they said this is the way they are ,I sent trick flow a pic they say its normal reply,I was told a low deck would not even bolt up,I measured it,8 7/16 or so in the center from side to side