Thank you so much for the response and the offer of the bell. GREATLY appreciated it. i did find one just a few minutes ago a few hours drive from me so i will get it. again i do thank you for the offer.
Ok that sounds great. i just got off the phone with a guy who may have one also he is near me to so he is going to look at casting number. i will get back to you asap. thank you very much for responding i appreciate it alot.
Hi all looking for a aluminum bellhousing for A833 that will work in a 71 Demon.
If you have something message me please with the bells casting number found in the lower right trans mounting bolt hole. it should be a 7 digit number. thank you in advance
not sure if bearing is same but I would think it should be. first of all check were the bearing rides if its scored at all change the axle to. get a new axle seal for sure they are cheap
to put the bearing in just start it with a block of wood if you don't have proper driver and tap it in
then...
Hello thank you for the reply greatly appreciate it. yes i am very much interested in a set if you are willing to part with it. saskatchewan is in canada i hope your ok shipping to me here. i have bought a few items from members from the USA before and it works out ok it just takes a little time...
Hi yes the trim that separates the rear quarte from the roof line on duster or demon body not swinger style and not the duster demon half or canopy style but the full top. thanks
Hi all looking for twin hood scoop trim that goes around the front of scoop. also would like to locate the rear quarter stainless trim for cars that had the FULL vinyl top 70-76 A BODY. Not looking for the canopy style. thankks.