mderoy340

Profile posts Latest activity Postings Post Areas About

  • any idea what static compression ratio is and what your heads flow? I have a new set that has not been touched but still have the smaller intake valves. Who did your head work for you?
    mderoy340
    mderoy340
    10.3:1 with 63cc chamber. Heads flow [email protected] IMM Indy LAX Iron heads 2.02 1.6 valves. Brian ported the heads
    Hey mderoy, I noticed in an older post you build a 340 with RHS X heads. I am working on the same combo now. Wondered if you would tell me a little bit more about yours sir? Thanks in advance.
    mderoy340
    mderoy340
    Not much to tell. It runs good on 93 pump gas 34* degrees total mechanical timing. pistons are flat tops .020 above deck, head gasket is .060 compressed which gives .040 quench. Hughes 1.6 rockers, comp cam xs274s sft. Runs high 11s low 12 depending on the air.
    Hello, Sorry for bothering you but i read a Old Thread where you said you Moved your rear end back 3/4 and Run a 255/70 on the street. This is something i have been thinking on doing to my Car. Do you have any pictures of your car with those tires on it? Or any Tips?
    mderoy340
    mderoy340
    Can't PM your inbox is full
    limegreen70
    limegreen70
    I cleared some messages. Sorry about that.
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top