The "V6" bars have been the trick for a long time. Had some on the car for several years. You have to watch the hight of the front end over time they will get even weaker and the car will start to bottom out on small bumps. But for a Dragstrip only car they work. Good luck and have fun. You...
I have been running a rear conversion u-joint old smaller to a 7290. 7290 on the center section. Been nervous about it for a while. I just keep it greased well.. that's the big reason to change or update the drive shaft.
Thinking about having a new light weight drive shaft made. Looks like not all companies make drive shaft yoke to fit the 7290. But it looks like the 1350 is everywhere. I beat the crap out of this car on the street and at the track. I have a Gear Vendors unit on the trans. It's output shaft has...
.50" is a lot! There are water jackets there. I have a set of AL cutters an have opened these heads up for roller lifters, but 1/2 inch off the outside makes me nervous. I have heavily ported these heads. But nothing like a 1/2 inch. But I have cut some of of it away. I question why the stick...
That was what I was wondering. My 69 Cuda had A/C on it but the people I bought it from had taken it out and threw it away. They had left the double crank pulley on the dampener. After putting the Edelbrock heads on I just used the larger outer pulley. I am now switching to a serpentine belt...
I actually use stainless spacers on the alternator bracket from Ace Hardware. They were inexpensive and several different lengths. They look good and last forever.
Is the bolt pattern on the dampener of a 340 the same as 440 or Hemi, that holds the pulley in place, or is the LA smaller?
I have a set of Edelbrock heads and need to add a 0.50" spacer so the alternator will clear the head. Not finding one for a LA motor but there is 6 bolt hole for a Hemi...
Took it for a little 200 mile run from Lansing MI to Saugatuck MI all two lane. It ran great. Shifted fine. It was just over 90° outside. The transmission ran hot went up to 210°. But there were curves, hills and several stop signs. Every time it dropped below 200° I hit a stop. Tried to cruise...
I dropped the pan & readjusted the rear band. 72 in, lbs 4 turns out. It is working fine now. It dose have an A&A Automotive reverse valve body in it and feels like it is not shifting/grabing as hard, but I have not driven it very hard yet. It was over filled with trans fluid to. The fluid was...
Was driving the other day. Backed out of my garage no problem. Drove 30 miles pulled into a parking spot. When it came time to leave had to give the motor a bunch more RPM to back out. Dropped my driveshaft from the rear-end. In neutral, It turned freely in one direction. The Forward direction...
Here is the porting I did. You can see how the push rod tubes interference. Opening them you have tobe very careful in the runners & in the tube. You can see them on the top of the whole head. The holes at the top close to the outside.
The front. This is 3/8 thick. I believe 1/4 inch thick would have been much easier to work with/bend. My wife was heating the top and I heated the bottom. Used a Harbor Freight break to bend it. It fits tight to the hood. It was very important to use two heat guns. We also heated the break as...