Recent content by mopar_mudder

They don't have a separate diagram for Sport that I can see. Either way the math doesn't add up unless I am missing something

That is the bottom of the page, their is nothing under it. The headings are under the diagrams. B &J dimensions are on top of the page.

It is a factory 74 body manual. Just came it the house and manual is out in the shop so I have to check tomarrow and see if the top and bottom diagram have the same dimensions. But L should be for the Dart from what I understand.

So I am checking my frame dimension to make sure I keep everything square when installing new quarters. This is on a 1974 Dart Sport. I have the body service manual with dimensions in it. Problem is the dimension it has for the rear spring eye to eye of 57.26 isn't even close. Mine is more like...

Just on the back of mine. I don't mind them, but need new rubber boots for them at the very least.

Does anyone make new or rebuild kits for the 5 mph rear bumper shocks?

I found where it goes, it is just not make correctly as my last pictures shows. Just like the Front inner fenders, firewall, battery tray, rear outer wheel wells, its kind of a joke at this point....oh well keep fixing them. Oh and by the way if you order the Trunk Floor Extensions do not...

Well here is the original next to the report. Needs modification to work of course, along with the quarter panel. Some day I hope to put on a body panel that just fits and is made correct, not on this car it doesn't look like.

I looked some more and I think you are right, but it is not made right for the 74 Dart. Why is it you have to modify every reproduction part to make it work, really frustrating. As I look some more the 1/4 panels are not made correctly either. At the rear the originals wrap around 90 degrees on...

Made it to the back of my 1974 Dart Sport restoration. Working on new quarters, wheel tubs and trunk floor. Ordered these truck floor extension end caps a couple of years ago because they say they fit my car. For the life of me I can't see where they would go. Is this a screw up in the listing...

Does anyone make a correct inner fender for a 74 Dart Sport? The one I got from AMD are not right, the drivers side i delt with. But the passenger side is way different where the charcoal canister mount, these reproduction pieces really pass me off that they fit multiple year but not correctly...

I could use both sides but need it pretty soon. If I can get it I will just have to start fixing them this week end.

It is mainly the lip where the firewall attaches and about 2" up from the rocker that is bad. I can make it if I have to, it is just alot faster to replace then make and seam weld in pieces.

Sorry it is a 74 Dart Sport

I don't think so but does anyone make the panel that is between the A pillar and fire wall? If not looks like I am making and fixing.