anyone have a part number for the male pins used in the steering column connector. rewiring my car and want to replace the pins to keep splices down to a minimum.
out headliner came with the vinyl already installed..kind of worried that if i trim it. it will cause the headliner to start failing and.plus th vinyl is rapped over the edge if the plastic
Has anyone installed a classic industries abs vinyl headliner in there car. Do I need to put my windshield back in before pulling the gasket back over the headliner? Then did you also have to trim the headliner to fit correctly in the front corners so the gasket lays flat and not rippled. 72 demon
My wire diagram.
the green represents the low speed wiper
the purple represents the high speed wiper
the orange represents the park for the wiper.
the green and purple function as normal with the relays. to make the park function work like it should once the wipers are turned off i had to change...
Anyone good with wiring relays. I got a spdt relay I want to wire up. I know how to wire it but want to see if can wire it differently. I know current flows from terminal 30 to 87. But I want to wire it so current flows from 87 to 30. That way I can wire 30 to the one point with 2 different...
The autec8 is the module that will control the wiper motor with a momentary push button switch. Press the button for 1 sec is low. Press again 1 sec is off. For high is the same steps but you hold it for 3 sec. The hard part will be to wire the led in the switch to light up while in use. So...
What I'm doing is replacing my old wiper motor with a new one. But I'm also going to be using an autec8 wiper module to allow me to use both speeds of the motor with a non locking push button. To wire the autec8 up I just need to know what the 4 pins are on the motor. Since my wipe wiring has...
I'm replacing my wiper switch with a push button switch. I know that will only give me one speed but that's fine with me. I dont drive the car in the rain as it is but still want a wiper just in case. So heres my what I need help with. It's a 2 speed motor and need help with what spade is for...