Recent content by Moparpuller

Ok. Thanks

Does it have low band apply in 1st

What is the turn around time and price on this. Thanks

I have to extra dashes at my moms house. I will look tonight and see if the have the bracket and screw on them

I have a 68 dart that I’m putting floor pans in and I’m need of the 4 floor supports that come out from the inner rockers. Thanks

Mohawks are a very good lift. I worked around one that was probly 30 years old and had no problems. We have rotary’s at the dealership I work at. Put in around 2002 and they have only replaced maybe 5 pumps total. Very good lifts in my opinion

thanks. It had schumaker tri ys on it but he had a set of ceramic coated long tubes for it as well that I’m going to try and put on. It has an Offy dual quad with edelbrock 600s on it and I also have a Weiand 8008 dual plane for it. I put 3.55s in It has a tci trans with an 1800...

Trying to actually id the cam And see if it is a good fit for the combo or would be best changed out

I have a 68 dart with a 383 that I inherited from my dad. The motor was built at least 20 years ago but never ran until this year when I got it running. I tore the engine down due to slight oil consumption and am trying to figure out what all was done to it. I talked to the guy that...

Can you get a price on shipping to zip code 52627. Thanks. Grant

1,100. With extra side shims and adjusters. They have less than 2 hours run time

I have a set of Harland sharp 1.6 ratio. They have blocks with .180 offset. Possible to have your saddles milled off and use the blocks

In box is full. Interested in front brake parts. Will you be attending the cedar falls Mopar race in june

What bolt pattern are the axles

I’ll take then