Recent content by OLFOOL

  1. OLFOOL

    Rotating exhaust valves

    Not original installed height or springs, never seen a seen or heard of 'rotators' before asking the question. I've only worked on a couple of SB heads previously and didn't run into this issue, been advised that it's not a drama if the valves can rotate as they are.
  2. OLFOOL

    Rotating exhaust valves

    Never noticed before but the J heads I have just bought, the exhaust valve once fitted I can rotate the valve when the locks are fitted, is this normal as I am quite new to small blocks. thanks.
  3. OLFOOL

    [WANTED] SB Milodon Street Stainless Valves #45645

    Want to buy 8 small block Milodon exhaust valves or same specs in another make 1.6" head, .371 (3/8)" stem, ideally 4.998"-5.02" long with single groove. I am in Australia but more than happy to pay for shipping.
  4. OLFOOL

    XE285HL in 360

    That spec info is off the comp cams site
  5. OLFOOL

    XE285HL in 360

    Just after some timing numbers for a XE285HL Comp Cams hydraulic flat tappet cam for my 360 that I am currently building. I am using the KB Pistons calculator to work out compression, it asks for the Intake Closing Point (degrees) ABDC @ 0.050 lift plus 15 degrees, I have the cam specs but not...
  6. OLFOOL

    Edelbrock D64

    I just found the mob that I bought dual Edelbrocks off in 2014, ALLSTATE CARBURETOR & FUEL INJECTION 143 Brightside Avenue Central Islip, NY 11722 When I fitted them that they set up it worked perfectly out of the box. I messaged them today
  7. OLFOOL

    Edelbrock D64

    Wasn't intending to port them just use as is.
  8. OLFOOL

    Edelbrock D64

    I bought a pair of 600 edelbrocks a few years ago off a mob in I think New York state in the US. They specialised in dual carbs etc and they were set up and worked great straight out of the box. I can't remember who they were :(
  9. OLFOOL

    Edelbrock D64

    If you guys hear of a D66 being sold I'd like to hear about it, thanks
  10. OLFOOL

    Edelbrock D64

    These you bought off FWDLK Frank a couple years ago?
  11. OLFOOL

    Edelbrock D64

    Has anybody used an Edelbrock D64 dual quad inlet manifold on a 360, I believe they need a modification to fit? What carbs are you using? TIA.
  12. OLFOOL

    Crankshafts

    Hoping to use magnum crank with my LA pistons rods balancer etc
  13. OLFOOL

    Crankshafts

    Doesn't look like anyone has actually done it here.....
  14. OLFOOL

    Crankshafts

    So if I get the magnum crank I will need a magnum balancer, I am using a steel flywheel for a 4 speed set up, I would like to think that it should all come together with a full rotating balance.
  15. OLFOOL

    Crankshafts

    Yes, 360 LA cranks are getting hard to find, have a bloke that has a magnum crank hence my question.
Back
Top