Recent content by pntastar69

1967-Dodge-Dart-any Products | Pypes Performance Exhaust

Lost ours in February after 13 great years.

I have 2 plastic PCV Valves. Both of them rattle. I f I blow into the hose barbed end on one of them, it's totally occluded. The other one has a small amount of flow felt. Which one is good?

Not sure what you mean by "On the 3/4 lever, having it the other way meant adjusted to the end with some threads actually disappearing which I didn’t like.". You mean you ran out of adjustment? Is the 3/4 rod the correct length? I see you are looking for another lever. The one in your post...

They should work. That's why there are adjusters on the rods.

Per Accurate Exhaust A-body Tips

"Quarter Stick" is an automatic.

Lay the tunnel in place, trace it on the floor, measure 1.5" inward around the mark and cut away.

Had the same issue 14 Ram, 5.7 at 65k. Hooked up w/a friend who was a Parts MGR at a Chrysler dealer. Got new manifolds, gaskets and bolts for $450 n change. Had 2 sheared bolts on the front left side and 1 off the right side. I was able to remove 1 of the 3 but had a friend weld the nut to...

Sun block, hat and pop-up tent.

I used New England Chrome a few years back to rechrome 69 Dart tailight bezels and bullet turn signals. Great work. New England Chrome Plating | Family owned since 1965

Mine

You have mail.

Right here.

Ditch the 90 degree adapter and buy this. I can run any length oil filter with TTI's on a small block...