Recent content by pro451bee

Some people get that TDS to extreme and are blind to there own cult.Stupid is as stuid does.

The rear axle is bent some if its toed out that much in the rear , not helping you much , also some tires are more horrible at traming than others.

Your car does dog track a bit and is not ideal, I like to get the rear axle dead nuts square , always makes a better drive , however both the rear wheels will be toed out still , witch would mean the rear axle is slightly bent. can be corrected at a frame shop. I did a 83/4 once on an alignment...

You will need two of those PNs to get the two for the front. the rear I used large thick washer from any hardware store along with matching flange bolts . Only reason I ended up with those ram washers was wa had a run of bad electric PS racks at one time and the replacement rack had extra...

That looks like it , and yes it centers the frame nicely

2020 ram steering rack mount

Id like to know how it feels too , maybe you should lift up the front of the car and looen up the steeing column to fire wall screws and rotate the steering wheel left and right then re tighten . Could bee production tolerences at the mounting. Should be easy to turn the wheels by hand , jacket...

318willrun is correct , modern vehicles don't have real gauges , as I was told they are merely virtual gauges and will tell you what the manufactures want you to see. None are a directly wired gauge. All pulse width modulated thru the buss and software .The fuel and tachometers are fairly...

That comp muscle magnum cam looks like my choice for a 383 with 3.23 ,that high lift one will idle and drive around awful and have stink exhaust, that was my experience any way .Way easy to over cam a 383.

I can see it on my home monitor?

Close up of the special washer I used on the front QA1 mount

Exactly , lots of newer car designs utilize this type of sub-frame attachment , however using much thinner steel than QA1. Some modern vehicles even have isolated rubber around the ferrule , Look at a modern LX rear sub frame.I used a machined washer from a late RAM P.S. rack mount hardware that...

Get skinny-er links , spacers?

Old tires will ride rough too , how old are your tires?

If you just bolt them in , get some 2 inch spacers into the frame so you can tighten the bolts without crushing the frame rails , like the trans cross member bolts. A good hardware store has them or cut your own from thick wall 1 inch tubing. There are drain holes in the frame rails , and use a...