Recent content by Rbob

I stitch welded completely to avoid excess heat on a rotisserie, ran the e-brake cable thru the subframe by drilling holes where the cable naturally crossed the subframe and used a big pry bar to make the holes fit better and rerouted gas line. There was a gap for the fuel line to cross over.

Looks like the smaller one:

Ok, got my heads back. Machine shop was kind enough to mark different heights, used a bridge and measured to a inserted valve for a zero point, in no certain order: I need to look again but I believe only the exhaust seats were installed and not all were hardened seats.

You are more than qualified, I will send some pics when I get back from the machine shop, I did discover oversize seats (1/4" depth) that say to set at 7/32" and top cut to finish, in my case they may help. Laughing at myself because you probably already know this.

yes.

Correct, hard seats were installed too deep. I am not familiar with seat replacement but it seems I need a taller seat, just fear someone cutting into the water jacket..

Looking for some guidance and suggestions, My heads have been cleaned up, machine shop says someone has installed valve seats and many are 25 - 60 thousands too deep which I can remember when that was done in the 80's. Scary parts is recommended replacement with oversize seat inserts with risk...

This:

How do I attach pdf files? I just read a bunch of posts on this, I realize what a heated subject it is. Not meant to discredit anyone, just sharing.

I know this is an older thread but I posted Sanborns Pics on last post #398. Typical Oiling Modifications - Page 14 - Moparchat - Home of MOPAR enthusiasts worldwide!

PRH, I am very impressed and thanks for sharing all the pics. I have a set of T/A heads that need this kind of work. pm sent.

Pics sent.

I have found Sanborn's Oiling Mods with pics. They were saved on my computer. I have saved it a pdf file with pics. How do I upload it?

I have found Sanborn's Oiling Mods with pics. They were saved on my computer. I have saved it a pdf file with pics. How do I upload it?

Still have the yoke? 8 3/4 50.00 shipped from 32127,port orange ,fl,no rust or grooves,if interested please pm me as i don't watch my posts.