Recent content by rdunnam

Side question, what intake and carb are you running in your profile pic of the 392?

I like your set-up. Is that a 70-72 front cap?

I just need to get these details in my mind once and for all. In '70 they came out with the 14" and 15" rallye available for A and E bodies, (maybe other bodies?) The a body wheels were 4 x 5 up to '73 ? Then changed to 4.5 x 5? I know this is not E body forum but did all those start 4.5 x 5...

el5Dart, I've found out over the years that the best AC folks you can trust and even work with, looking over their shoulder, are ones that do it out of their home garage, they have the skill, tools, etc and do it on the side for their friends, neighbors, others. You need to start asking around...

el5Dart, Are you having fun with the silver dart w black hood? Looking through my previous post and catching up with some folks.

Thanks Dan!

SlantSixDan, Once I obtain an electronic distributor ('73-'76 non lean burn), I'm sure one can benefit by changing springs and weight slot length to "curve" it slightly. I understand a "good" curve for my short bed D150 automatic would need to be slightly different that say a '64 valiant due to...

Thanks a lot Dan!

Looking at a BBS from a '73-'74 p/u to replace the lean burn carb on my '84 p/u. It has the auto choke, pull-off, cable type throttle connection, may end up having to use a kickdown cable, if and once I get it, I'll check out to see if the stock kick down linkage will work or not. The...

You will need an intake that will bolt onto the magnum heads, straight down vertical holes. Can use your distributor. Your exhaust manifolds should bolt up as well. Professional Products 55026 Professional Products CrossWind Intake Manifolds | Summit Racing

Had a few questions on the 5.9. Is this short block rebuilt and assembled with those new pieces you listed or comes with those pieces ? Does it have a cam, timing set, cover? Which oil pan, a stock truck pan?

How much do the 4 speed /6 bellhousings run, any available? I know there are some, friend and I looked and searched for one in early '80's, couldn't find one, wasn't sure then if they existed except for a truck-large flywheel. But as of lately, I understand they do exist and many of you forum...

What is recommended as a 1 bbl replacement for my '84 (D100) lean burn carb? I will swap the distributor out also, add control box and resistor for the basic electronic ignition type.

What a transformation! That's nice and it shows the hard work it takes to bring one up. Looks great. There's a single handful of Mopar folks here in Tupelo, you have a gang of them in Mempho? I'd like to connect up w/some more. I'm looking for another A-body, working on pickups now, but want...

Thanks, I appreciate you doing that.