Recent content by red67cuda

Still waiting to here from you. Please let me know if thee car is still for sale. Thanks

Is this car still available?

Do you still have this car? Are ther more pics? Thanks

Is the car still for sale? Can you email me more pics. What is the rust like and is this the original color? Thanks

Up for sale is a really HOT 1967 Plymouth Barracuda Coupe. Factory 273 commando (235hp) 4bbl Motor, 4 speed, 8 3/4 Suregrip posi 3.23 rear end, AC, Front Disc Brakes, Power Steering. Great driver that looks and runs good and has potential to be whatever you make it! The original factory color is...

Yes I did the drill as well. My problem has been solved thanks to Redfish and his DemonIVR voltage regulator. My VR was toast and the root of my problems. Redfish got me through the entire nightmare and my gauges are all working and now I am on to steering and supension. I highly recommend the...

Just so you can drive and start the car while the gauges are out. Otherwise no go. Thanks

Great Thanks again. What would you recommend for a sub power supply? Also any ideas on where to locat a fuel gauge. I checked ebay and google but know luck. Thanks Redfish your the man. I hope I can help you out some time:)

Back again, I made some go0d progress today as well. I pulled the cluster and tested all 3 gauges with a battery as suggested. All three had positive movement. The pc board is in excellent condition as I had already cleaned it up. Seems like the voltage regulater in the Fuel Guage is bad? I also...

Ok Mr RedFish, I have begun to work the Gremlins out! After a good night sleep I went at it again today. The first thing I did was take apart my original relay switch. It appears that someone else had done a little solder work on the housing once before. I connected the relay out of the housing...

Thanks, the battery is at about 12.5 volts. Newer optima. I checked the column harness connection and it was good. I am only getting about 9.5 volts through the starter switch wire which must be contributing to the issue. I am in agreement with Redfish and need to go back to square one when the...

Ok, I put 12 volts to the switch spade on the relay and nothing happend. I then went back to my old relay (reinstalled it)which worked before I pulled the cluster and that one was not working as well. With 12 volts on the swich spade there was obviously no voltage at the starter lead. All this...

Thanks for the reply. I grounded the NSS spade and still no start. I also measured the voltage of the ignition switch start wire and only reading 9,6 volts. The battery reads 12. I also put my old relay back in which is correct and still no luck. All was good until I pulled the instrumnet...

Thanks for the input. I get my test light to turn on at the switch relay but I have not measured the voltage at the end of the ignition wire. I will check that. I can start the car by jumping at the switch relay with a screwdriver. I also bought a new relay switch but the new has the nuetral...

PS: yes the amp gauge wires are connected.