Ricks70Duster340's latest activity
-
Ricks70Duster340 reacted to TrailBeast's post in the thread Classic Auto Air update 4/18/2024 finished. with .All done, 40 degree AC and killer heat full climate control. -
I did install a drain plug in the stamped pan... After this leak, I really didn't need any more practice on pan removal. I don't regret...
-
Ricks70Duster340 replied to the thread Classic Air Glove Box Fix.I watched your Youtube video on the install. Well done, and now you're famous!!
-
Go back to the basic tune and begin making ONE change at a time to see how it affects the engine, how it runs out and how it drives...
-
Ricks70Duster340 replied to the thread Gets hot and stalls out.Post #119 asked about the troubleshooting results. I see you're running in several directions. You really need to focus on why the...
-
Ricks70Duster340 replied to the thread Installed this last weekend.Once the stamped pan has been distorted it is hard for them to reseal. You won't have any issues with the cast one you got.
-
Ricks70Duster340 replied to the thread Installed this last weekend.The stock pans worked well until the flange got distorted by over tightening. I too went aftermarket for more fluid capacity, but the...
-
Was chasing a nasty transmission leak. Replace the stamped pan for this beauty. So far, Knock on wood, it is dry under the car!!
-
Shorter stroke, bigger bore, better heads? But the biggest reason.....the distributor is in the front so you don't have to be an...
-
Ricks70Duster340 replied to the thread Vacuum Secondary Conversion.On the street, a vacuum advance is key to economy. Without it you're leaving a lot on the table. The vacuum canister on OE style...
-
Ricks70Duster340 reacted to MOPAROFFICIAL's post in the thread "Warning" Don't Bench Bleed Me with .That because you use short strokes like a chinamen does. Lol My advice to people and what I do...is put it in the car and do it with...
-
I would pull the heads and then see if it turns
-
Ricks70Duster340 replied to the thread Cars that sit awhile..It will be fine as long as you drive it long enough to thoroughly heat the engine & exhaust system. Fuel in the tank goes bad if not...
-
2.76 axle, mild cam, the 650 AVS2 will be perfect. Congrats on not falling for bigger is better...
-
Ricks70Duster340 reacted to junkyardhero's post in the thread Replacing my Intake Manifold Question with .paper towels. i have a GIANT roll of the heavy blue towels (thanks U-line!) and they work great. i lay those down in the valley and then...
