Recent content by Ronjon

No actually just sold both plates, sorry.

reduced To $25 each plus shipping

Two 727 small block transmission dust shields. $30 each plus shipping.

I have a complete 1972 Slant 6 and 904 trans with 48k miles removed from my Dart in Feb 2023. Both ran excellent, removed for a 340 swap. Engine is complete from air cleaner to oil pan, includes all brackets and power steering pump, trans Kickdown linkage. Also includes the original radiator...

Received it today, thx

PM sent, thank you

Near Carbondale 18407

Looking for a driver’s side LH shock plate for an 8-3/4 rear, or possibly a pair. Picture is the one I have, I need the opposite side. Thx.

PM sent on #5 column cover

You will also need the correct A body exhaust manifolds or headers, alternator, power steering, and AC compressor brackets, belts, hoses, fan, shroud, fuel line, throttle springs, Kickdown linkage, transmission lines, etc if the replacement motor doesn’t have them. You can probably use the /6...

I’d be interested in the rear axle if you decide to part it out

Good instructions from Hughes, especially checking lifter bores and setting up to start on the first crank: https://cdn.shopify.com/s/files/1/0597/4841/7719/files/camshaft_instructions_Mar20.pdf?v=1649262548

Thank you everyone for the responses. 67Dart273, I followed your instructions, everything checked out as you described. I ended up replacing the VR and it fixed the overcharging issue. I did check the case to ground on the old VR first and it checked out good, so I replaced it. Thanks again...

Tonight my 72 Dart started overcharging when I took it for a short ride. The ammeter would peg when I stepped on the throttle, at idle it would be closer to center of the gage. The voltage regulator was smokin hot to the touch. I read through some threads here and tested the alternator field...

Is this what you need. Rochester Carter 5/8-20 Brass Fuel Inlet Fitting 5/16" Inverted Flare | eBay