Recent content by roylerumble

Looking for hinge covers for a 69 valiant bench, black, shipping to Edmonton Alberta Canada T5L 2Y9

pmd

she polished up with a bit of fine paper!

How do you ensure the correct clamp load is applied? Is that dictated by the rotation of the cam? Is the key on the nose a marker? Where should it be located, ie 12 oclock?

bought a 96 land rover discovery. Running really rough, had a coolant leak, picked it up super cheep. Was running rough because a vacuum line was cracked right at the intake, pulled it off, clipped it a bit shorter, put it back on. Coolant leak was an exchanger, torqued the bolts down, stopped...

LOL. Race motor = way more ponies than I have or plan on having. Thanks for the help! I heard there are two types of timing chains, one works with eccentric, one does not. Any truth to that?

I had a 408 stroker built by a local builder. He made the assumption that I was going to run an electric fuel pump, but I want to go with a high flow mechanical. The motor is only 450hp tops, and I don't plan on making it make more (cast crank). He put the pictured below on the left spacer...

That pic makes sense. I think I still need to cut that oblong hole in the vertical edge of the f ender just in front of the pin to be able to access the bottom bolt on the pin. Any chance you can get a few measurements from the edge of the fender to the center of the pin, and maybe the edge of...

That's the one! I want to attempt it myself. I'm in Canada, so buying anything from the states stings with exchange, shipping, duty, and brokerage.

So cool! I didn't know they existed, they didn't when I was looking before! Thanks!

to cut the access hole in the front of the fender, the hole you'd drill would also go through the sheet metal on the rad support. At least that's what it looks like in the pics I've seen.

I remember seeing an old "how to" on bigblockdart on modifying a column shift to remove the lever for a floor shift. Cant find it any longer. Looking to restore an 67-69 column and do the modification. Any links to the resto and modification?

I searched the vaults for some info on this topic, but I'm still a bit unsure about where to drill holes for the hood pins. My car's a 69 valiant and I'm installing a fiberglass 6 pack hood. I know they didn't have pins from factory, so I figured I'd go with the location on a Duster. I'm...

great article, if you have ton's of cash. I so badly want to do a G3 in my 69 dart, but don't have the cash to drop on all those fancy parts...

So I'm having issues with fittings and hoses matching up my federal PS pump to the rack and pinion on my RMS AlterKtion, so I found a saginaw and brackets and I'm attempting to do the swap. Having issues on alignment, I'd say the pulley on the pump is about 3/16" too far back. What is an...