Looking to reproduce the drawings in AutoDesk Fusion 360. From this than produce a model that allows parametrically to change cam lift duration stroke length etc. Fun winter project.
thanks,
Ron
Hi All,
I have a buddy that is spending the winter in Florida getting away from the snow and has been a great friend to my son and I working on on his Dart Swinger. My friend has a beautiful Barracuda. I would love to find a snow globe with a barracuda in it to send as a gift. Any ideas would...
Hi All,
I am still looking to get more comments I can take with me to evaluate the condition of the block. Truth is I am driving 5 hours to pick it up, unless there is a crack down the middle it’s coming home. Can someone maybe give me its value $$ as it sits as a clean short block?
Thanks
Hi All,
We came across a great deal we felt we should jump on. It is a 340 short block standard bore. The current installed engine in are 1970 Dart Swinger is a 340 bored 60 over and we worry it is just a matter of time before it gives out. But it has all the goodies on it.
For those who know...
We can not figure this out. Spent hours customizing the new wire set from old 8mm set to (Taylor ThunderVolt 50 10.4mm Spark Plug Wire Sets 98055). ran fine down the road. Put under load and it blows the cap half off. Tried a few times. We put the old wires back on and no problem under load! Any...
Well here is what I noticed last night. I am not sure if it came from re-tightening the screws or the root of the problem. Either way looks like my FAB guy has a little tedious work to fix the crack! I actually hope this is the problem and nothing down low in the fender. I appreciate everyone's...
The corner of the back hood on the drivers side has lifted what appears over night as seen in the photo. We loosened the hinge bolts to the hood while pushing down than re tightened. Helped a little but still way out. We removed the splash guards to have a look inside the fender at the hinge...