The warping is caused by thin plastic material and spring tension in the brass contacts. Wasn't warped when new. Became warped though some use, and cracked. It was the cause for the cancel feature to stop working due to mis alignment of the cam.
I don't recall but I have to believe all the...
So if a soldered joint creates a stiff spot next to a flexible spot, wouldn't a crimped connector create the same issue? And I have to believe vibration in the middle of a wire that is shrink wrapped is not going to flex to failure.
I've done nothing but soldered wire repairs and have zero...
If anyone was near me I would rebuild one for the price of the parts. I probably have enough spare seals and gaskets to do 4 right now. Not everything needs replaced when you get in there. I think they are fun.
I understand completely. I buy USA when I can afford it.. But these HF boxes are solid and half the price of anything else. It allows me to spend more on nice tools to put inside.
My Hughes rockers have been trouble free since I installed them on my 440. I did use the B3R geometry kit to get them centered up. Cam is a Hughes STL3842. Stealth heads.