Recent content by treetrimmer12

Sold

Sale Pending.

More photos.

Unable to finish project due to bad health. 73' new front end (disk Brakes), 75' 360 bored .30 over, .474 Hydraulic cam, headers, power steering, power brakes, 904 auto w/2500 stall, 7 1/4 posi rear, 72 dash and 71 steering column, 72 wiring harness. 2006 Mazda 3 bucket seats (need proper...

Still available as of today.

Could pay for shipping if added to price of the car.

Would you pay shipping costs? If so, you can PM me.

I'm prepared to reduce the asking price to $4,000.00 PM if interested.

Upon closer inspection, the rust is actually from a rusted floor pan and really bad repair job. The frame looks just fine. Replacing the front passenger floor pan should take care of rust problem. Unknown how long front end and steering has been this way. Lots of parts were replaced. Wheels...

Fore Sale: 1968 Plymouth Valiant Signet, Factory A/C, Slant-Six (225ci), auto trans, Bucket seats. Repaint in 2008 not original color and custom interior in 2014 changed from black to white. Still needs window channels and frontend rebuilt. Small rust below passenger fender at the door post...

I was concerned about the offset of the bracket. I will follow your advise, Thanks

Finished with pass side motor mount and fuel pump installation then went to drivers side. Motor mount rubber separated but bracket appears to be bent and not settled nowhere near where it should be. Unable to locate a pic of what the bracket should look like, attached is my drivers side motor...

Thanks. I did that after seeing your post.

Ok Thanks. That's what I'll do. Thanks again,

Just bought a 68 Valiant 2 door, slant 6. Fuel pump started spaying gas on first test drive after purchase. I finally got the old one out and replaced with a Delphi brand (standard replacement) from AutoZone. But while attempting to install, the left bolt was really hard to get started and the...