Recent content by Turbosmblk

Lean out the primary to bring the cruise into check. You will probably have to open up the PVCR’s once you do this as it will probably be lean at WOT.

@RogerRamRod yes that’d be fine. You just need some electrical switch to close so the brake will energize. It doesn’t care if it’s momentary or constant. I know it won’t work in your application, but I use the Holley efi software to turn on the Transbrake when in “neutral” so I can back up...

Yes the fluid passages use a new billet plate. Where your ~1.5”x2.5” plate that states 22XODLU is is where the Transbrake solenoid would go which. Call cope and ask for the Transbrake plate and solenoid. All that is is a fluid passage and with a solenoid in place your blocking fluid to that...

I have a cope Transbrake valvebody as well. You actually do have neutral. You get reverse by holding the Transbrake button while in neutral. 4th is operated like previously mentioned with the manual valve. Very simple. The valvebody didn’t “trash” his transmission unless there was something...

I used 1” rigid conduit cut to length and a piece of 1/2” key stock with a hole drilled in it so I could slip my caliper depth gauge through. Worked fine in my application. You also don’t need the “assembly shaft” either. Use your intermediate shaft and build the OD Section first then pull it...

Good ole “lean manufacturing” it’s a crock. We do it as well and with no overstock you can put yourself in a very serious bind if a line goes down that has “rush metal” I hate it

Biggest difference is shaft rockers on LA and pedestal style on magnum. Oil through pushrods on magnum and deck/head oiling on LA. Basically every part between the 2 series will interchange. You just have to be mindful of what you’re changing and the steps you need to take to make it work.

Myself as well as every turbo ls guy that has 2 nickels to rub together have had good luck with the evil energy ptfe stuff. So far I have had zero issues with it. Good fittings, assembles nice, and I had zero leaks. The entire car was done with this stuff. -8 supply -6 return y block at the fuel...

Ahh internet gold. I’ve been waiting for this. Can’t wait to see the outcome!

9.5” PTC FOR 727. Has weights for external balance 360. Can knock the weight off and run behind your internal balance engine. Has anti balloon plate etc. flashed 4800 behind a decent la-x headed engine in a 3700lb e-body with 3.55 gears. Total of 30ish street miles and 10 passes. $650 shipped to...

“Stock”

as much as any good built 904. They are a 904 front half and the OD section is the same from an a500 All the way to a 48re add or subtract some clutches/steels depending on the model. You really don’t need to add a bunch of OD clutches as I don’t know too many with cars that are gonna beat on...

this is interesting that they say they can build them with triple discs. I inquired with John Cope about WOT lockup function when I purchased my valve body from him and he stated that the single disk converter would slip (obviously) but he didn't state that triple disc options were available...

I think you interpreted that incorrectly. he is running an R3 due to the ritter being a pile of scrap iron from core shift.

Like I said I wasn’t trying to argue. We can just agree to disagree on this topic.